Lacerator
The Lacerator is an updated Superbank.
I have dropped a bit of the entry rocker from the original Superbank design, but have kept the mid through the tail rocker the same and kept the same hull contours (single to inset doubles).
This gives the Lacerator a bit more versatility getting into waves earlier, quicker through the flat spots, but without sacrificing any responsiveness in the pocket….where it’s home is.

Product Specs:
Dimensions: 6'1" x 18 3/8" x 2 3/16"
Tail Shape: squash tail
Construction: Proxy epoxy
Glassing: S-glass, Kevlar, Carbon Rails, Parabolic Stringers
Fins: FCS thruster setup

TITANIUM SERIES CONSTRUCTION

The Titanium Series construction features Parabolic Carbon-Rail Suspension System with Kevlar Compression Patch and high-grade flexural engineered epoxies. This is not a molded board. Built in-house from start to finish in our factory in Ventura, CA USA. This is the strongest, most high performance board that I make. Tested over the last five years and proven to be 5+ times stronger than any polyester board. The Titanium Series has an increased recoil and push-back out of turns and can handle the heaviest barrels out there. Made out of recyclable components. This construction available in all board models.

Tommy O, with a strategic textbook section-clearing functional backhand air…say that three times fast.
6’0″ x 18 1/2″ x 2 1/4″ Lacerator rounded squash tail

Out the Back

Eastern Surf Magazine

Crisscross a few oceans. Traverse a continent or two. Paddle down tot hat next unknown cove.
Wherever you venture this summer, let ESM’s annual World Travel issue show you the way.

And let’s be honest – the conditions at your preferred destination will probably blow doors on that
drably homebreak back East. So allow our Fall Board Forum to put the proper shred sled under your feet.
Tommy O’Brien did, and look where it got him – on an empty left, with a stunning backdrop in the distance,
without a soul in sight to interfere. Photo: Steve Reyes

Hi Charissa,